5- FRONT WHEEL ASSEMBLY

STEP 1

** Please note for the front wheel assembly, the bike should not be on kickstand.

Remove plastic protectors from each side of the front wheel

STEP 2

Remove the plastic wrap from the tyre (photo 3). After this step is done, the tyre should look the same as that in photo

STEP 3

Remove one nut and 2 washers from each side of the wheel

STEP 4

Pressing the brake arms towards each other and release the brake noodle from the noodle holder

STEP 5

Lift the bike and carefully lower the forks until the wheel axel fits nicely in the front

Ensure the rotation sign on the tyre is facing the correct direction

STEP 6

Insert the locking washer to the axel on the right and ensure it is locked just as shown in photo

**Please note the washer tap should be inserted in the hole on the fork so that it locks.

STEP 7

Then insert the second washer (photo 12) followed by the nut

STEP 8

Then hand tighten the nut. Do the same on the left. Now by using a wrench tighten the nut on one side a bit and then do the same on the other side

Repeat tightening each side a bit until the nuts on both sides are fully tightened. You should keep the tyre in the middle of the forks while you are tightening the nuts (The distance from each side of the tyre to the fork should be almost the same).