7- Rear basket assembly

STEP 1

IMPORTANT: Please note the steel basket should be assembled as far as possible to the bike saddle. Otherwise, when you sit on the saddle, your back might rub against the basket.

This step requires 2 flat bars, 2 curved bars and four small bolts as shown in photo

Please note the longer black bolts will not be used.

STEP 2

Put the steel basket on top of the bike carrier. Put one of the curved bars under the bike’s carrier. The curved section of the bar (the hill) should face downward

STEP 3

Now put one of the flat bars on the bike steel basket in such a way that the outer holes on both bars are aligned

STEP 4

Using the two bolts, half tighten the two bars together (photo 4). Do the same on the other side.

IMPORTANT: Please note the bolts do not need to pass through the holes on the carrier

STEP 5

Now fully tighten all bolts

STEP 6

Put the wicker basket inside the steel basket