4- FRONT LIGHT ASSEMBLY

STEP 1

Loosen the front light’s right bracket by holding the nut with a wrench and turning the bolt by an Allen key anti-clockwise. Do the same on the left bracket

STEP 2

Remove the nut and the washer located in the front of the right bracket. The bracket should look the same as the second photo below, after the washer and the nut is removed. Do the same on the left bracket.

STEP 3

Install the front light as shown in the photos below by using a wrench and an Allen key. After the front light is tightened to the brackets, please adjust the angle of the light so it faces forward.

NOTE: If the front light’s cable is passed in between the front forks (and not from one side of the fork), then you need to unplug the front light cable from the connection point, assemble the light and then reconnect the connection. Before reconnecting the light cable ensure the two sides of the connection are aligned otherwise, the pins might get bent.