6- Front mudguard and Front mudguard and

HOW TO USE THIS MANUAL
STEP 1
Remove the bolt from the front suspension fork arch by an Allen key
STEP 2

Install the front light and mudguard in a single step by using the same bolt, which was remove in the previous step (photo 2). Tighten the bolt by an Allen key. Before tightening the bolt, ensure the mudguard is on the highest position possible and does not rub against the tyre.

STEP 3

Install the front light and mudguard in a single step by using the same bolt, which was remove in the previous step . Tighten the bolt by an Allen key. Before tightening the bolt, ensure the mudguard is on the highest position possible and does not rub against the tyre.

STEP 4

Now attach one belt to one side of the fork and Insert the end of the mudguard brace between the belt brackets. Push the two brackets on the belt together so that the two holes on the belt brackets come as close as possible to each other. Now insert the bolt in the belt holes and try to fasten the nut from the other side by hand

IMPORTANT:┬áPlease note this step requires force to be applied to the belt’s brackets. Therefore It would be better if you can have someone help you with this step. One person should apply force to the brackets and try to keep the holes on the bracket as close as possible to each other. The other person should insert the bolt and try to fasten the nut from the other side

STEP 5
Now fully tighten the bolt by an Allen key while holding the nut by a wrench . Do the same on the other side of the fork